Installation (Van)
WARNING: This page is about a different variant/trim than selected.
- If assembling rocker arm assembly, place steel ball in cup area on rocker arm. Lubricate steel ball with engine oil. Install rocker arm pedestal onto steel ball and rocker arm. Install retaining clip. Ensure retaining clip is fully snapped into position.CAUTION: Install push rods with Copper end facing upward, toward rocker. Rotate engine with timing mark on vibration damper at 11 o'clock position before installing rocker arm assembly to prevent bent valves and engine damage when installing rocker arm assembly.
- Lubricate ends of push rods with engine oil. Install push rods in original location. Ensure Copper end of push rod is facing upward. Rotate engine until timing mark on vibration damper is at 11 o'clock position. To prevent bent valves and engine damage when installing rocker arm assembly.
- Install rocker arm assembly. Install and tighten rocker arm assembly bolts to specification. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure. Tighten bolts to specification.