Low-Pressure Oil Pump: Inspection
WARNING: This page is about a different variant/trim than selected.
- Inspect components for damage and wear. Install inner and outer rotors in low-pressure oil pump body. Place straightedge across low-pressure oil pump body so it is above both rotors. Using feeler gauge, measure rotor end clearance between rotor and straightedge. Rotor end clearance should be .0010-.0030" (.025-.076 mm).
- With both rotors installed in low-pressure oil pump body, use feeler gauge to measure clearance between outer edge of outer gerotor and oil pump body. Outer gerotor-to-oil pump body clearance should be .028-.032" (.71-.81 mm). Replace low-pressure oil pump if any measurement is not within specification.