LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1997 >> Taurus G, AX4N >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Removal & Installation >> Hub & Wheel Bearings >> Installation

Hub & Wheel Bearings: Installation

  1. Place sensor ring over new hub assembly. Place ring and hub down onto Sensor Ring Installer (T88P-20202-B). Place Ring Replacer (T89P-5493-B) between hub and press ram. Press hub into sensor ring.
  2. Place hub and bearing assembly on spindle. Install a NEW retaining nut and tighten to 188-254 ft. lbs. (255-344 N.m). To complete installation, reverse removal procedure. Use NEW grease cap.
scientia non olet · About LEMON Manuals