LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1997 >> Taurus G, AX4N >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 3.0L V6 - VIN [U,1 & 2] >> Removal & Installation >> Water Pump >> Installation

Water Pump: Installation

  1. To install, reverse removal procedure. Lightly oil all bolt and stud threads, except bolt requiring Thread Sealant (D8AZ-19554-A), before installing. See Figure. Apply Contact Adhesive (D7AZ-19B508-AA) on gasket and install on water pump.
  2. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS . Refill cooling system. Check for leaks when finished.
scientia non olet · About LEMON Manuals