LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1997 >> Probe Base, Standard >> Repair and Diagnosis (Single Page) >> General Information >> Restraints >> Supplemental Inflatable Restraint System - Air Bag Deactivation Procedures >> General Motors >> Disabling & Activating Air Bag System >> Disabling & Activating System (Cutlass Supreme, Lumina & Monte Carlo)

Disabling & Activating System (Cutlass Supreme, Lumina & Monte Carlo)

  1. Turn steering wheel to place wheels in straight-ahead position. Turn ignition switch to LOCK position, and remove key. Remove fuse No. 21 from instrument panel fuse block. Wait 10 minutes.
  2. Remove sound insulator from under steering column. Remove Connector Position Assurance (CPA) clip, and disconnect Yellow 2-pin connector located at base of steering column.
  3. Remove instrument panel compartment (glove box) door from right side of instrument panel. Remove Connector Position Assurance (CPA) clip, and disconnect 2-Pin connector from passenger inflator module pigtail.
  4. To activate air bag system, connect Yellow 2-pin connector(s). Install CPA clip(s). Install fuse No. 21. Install sound insulator and instrument panel compartment door.
  5. Staying well away from air bag module(s), turn ignition switch to RUN position. Ensure AIR BAG warning light flashes 7 times and then goes out. See SYSTEM OPERATION CHECK .
scientia non olet · About LEMON Manuals