LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1997 >> Probe Base, Automatic >> Repair and Diagnosis (Single Page) >> Steering >> Power Steering >> Steering System - Power Integral Rack & Pinion >> Removal & Installation >> Power Steering Pump R & I >> Removal & Installation (Taurus & Sable, C-II Pump)

Removal & Installation (Taurus & Sable, C-II Pump)

  1. Disconnect negative battery cable. Remove drive belt and generator. Drain and remove radiator coolant recovery reservoir. Drain power steering fluid. Remove power steering return and pressure hoses.
  2. Remove idler pulley and power steering bracket bolt located under bolt tensioner mounting. Remove 2 nuts from power steering bracket mounting studs. Remove studs, power steering pump support and pump.
  3. Clamp power steering pump support and pump in vise. Using Steering Pump Pulley Remover (T69L-10300-B), remove power steering pump pulley from pump. To install pump, reverse removal procedure. Refill and bleed hydraulic system.
scientia non olet · About LEMON Manuals