LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1997 >> Probe Base, Automatic >> Repair and Diagnosis (Single Page) >> Steering >> Power Steering >> Steering System - Power Integral Rack & Pinion >> Removal & Installation >> Power Steering Pump R & I >> Removal & Installation (Continental)

Removal & Installation (Continental)

  1. Disconnect negative battery cable. Turn air suspension service switch off. Air suspension service switch is located in luggage compartment. Remove radiator upper sight shield. Remove accessory drive belt. Evacuate A/C system. See appropriate A/C-HEATER SYSTEMS article in the AIR CONDITIONING & HEATER section.
  2. Raise and support vehicle. Remove 5 push pins and 3 screws from lower radiator air deflector. Remove lower radiator air deflector. Remove power steering return hose from combination power steering and transmission fluid cooler.
  3. Drain power steering system and reinstall return hose. Remove A/C manifold, tube and A/C compressor. Disconnect power steering pressure hose and reservoir pump hose from pump. Remove 4 pump-to-engine bolts and pump. To install pump, reverse removal procedure. Refill and bleed hydraulic system.