LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1997 >> Aerostar Van Window >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Rotor >> Removal & Installation (2WD)

Removal & Installation (2WD)

  1. Raise vehicle and support with safety stands. Remove wheel and caliper assemblies. Remove dust cap, cotter pin, nut, washer and outer bearing. Carefully remove hub and rotor assembly. Remove inner bearing and seal.
  2. To install, reverse removal procedure. Adjust front wheel bearings. While rotating rotor, tighten adjusting nut to 17-25 ft. lbs. (23-34 N.m). Back off adjusting nut 120-180 degrees. Install bearing retainer and NEW cotter pin.
scientia non olet · About LEMON Manuals