LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Transfer Case >> Installation

Transfer Case: Installation

  1. Clean gasket surfaces and install new transfer case-to-extension housing gasket. To complete installation, reverse removal procedure. Tighten transfer case-to-extension housing bolts in sequence. See Figure .
  2. Ensure White marking on vent hose is positioned in notch on shifter (upper end of tube should be 3/4" above top of shifter and just below floor pan). When installing shift lever assembly, ensure large bolt is tightened first, then small bolt.
  3. Tighten bolts to proper specifications. See the table for TORQUE SPECIFICATIONS  . Fill transfer case to bottom of filler hole with Mercon ATF (XT-2-QDX or DDX).
scientia non olet · About LEMON Manuals