Clutch Master Cylinder & Reservoir: Removal
- Prying retainer bushing and push rod off clutch pedal pin, disconnect master cylinder push rod from clutch pedal. Remove Clutch Pedal Position (CPP) switch. See CLUTCH PEDAL POSITION (CPP) SWITCH .
- On Aerostar, slide clutch master cylinder reservoir out of relay bracket. On Explorer and Ranger, remove clutch master cylinder reservoir screw from cowl access cover. Disconnect clutch slave cylinder hydraulic line by pressing White retainer bushing with Disconnect Tool (T88T-70522-A) while pulling on line. See Figure . Plug line to prevent leakage.
- Disconnect line from mounting clips. Remove clutch master cylinder bolts from dash panel. Remove clutch master cylinder.