AX4N & AX4S (Taurus & Sable)
- Remove steering column release lever (if equipped). Remove ignition lock cylinder. Remove upper and lower steering column covers. Place shift control selector in OVERDRIVE (DRIVE on vehicles equipped with transmission control switch) position.
- Hold shift lever against rear of stop with a constant force of about 3 lbs. (1.4 kg). Loosen shift indicator cable retaining screw. Rotate thumbwheel until pointer is centered in appropriate position. Tighten retaining screw.
- Cycle shift control selector through all gears to ensure proper operation. Install upper and lower steering column covers. Install ignition lock cylinder and steering column release lever (if equipped). C6, E4OD & 4R70W (Bronco, Expedition, Pickup & Van)
- Remove lower steering column cover. Move shift control selector until in lowest gear position. Move shift control lever up 3 detent positions.
- Hold shift lever against rear of stop with a constant force of about 3 lbs. (1.4 kg). Center pointer in middle of DRIVE (OVERDRIVE on E4OD transmission) position, by rotating thumbwheel located on right side of steering column. Remove pressure from shift control selector and install lower steering column cover.