LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Removal & Installation >> Automatic Transmission >> 4R70W Transmission >> Installation (Bronco, Pickup & Van)

Installation (Bronco, Pickup & Van)

  1. Lubricate torque converter pilot with chassis grease. Install torque converter into transmission. Rotate torque converter to engage drive flats with pump gear.
  2. Raise transmission into position. Torque converter will move freely with respect to flywheel when it is properly positioned. Install and tighten transmission housing bolts. See TORQUE SPECIFICATIONS .
  3. Reverse removal procedure to complete installation. Use NEW "O" ring on filler tube. Lubricate drive shaft yoke splines with grease. Align reference marks on drive shaft and axle flange.
  4. Fill transmission with Motorcraft Mercon ATF (XT-2-QDX). For fluid capacity and control cable adjustment, see appropriate TRANSMISSION SERVICING - A/T article.
scientia non olet · About LEMON Manuals