LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Overhaul - 4R44E & 4R55E Automatic Transmission >> On-Vehicle Service >> Valve Body >> Removal

Valve Body: Removal

  1. Raise and support vehicle. Loosen oil pan bolts and drain fluid. Remove oil pan, filter screen and "O" rings. Lift up wire loom guide and protector to disengage retaining pins from solenoid brackets. Disconnect 6 solenoid electrical connectors. Remove manual valve detent spring. See Figure and Figure .
    NOTE: DO NOT  remove center bolt from SS1 and SS3 solenoid bracket or forward bolt from TCC, CCS, SS2 and EPC solenoid bracket.
  2. Remove low-reverse servo bolts. Remove servo cover, gasket, piston and rod. Hold valve body in position and remove control valve body bolts. See Figure and Figure . Carefully ease valve body from case while detaching manual valve inner lever pin. Clean and inspect valve body thoroughly. See CLEANING & INSPECTION  .
scientia non olet · About LEMON Manuals