LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Overhaul - 4R44E & 4R55E Automatic Transmission >> On-Vehicle Service >> CCS, EPC, TCC, SS1, SS2 & SS3 Solenoid >> Removal & Installation

Removal & Installation

  1. Raise and support vehicle. Loosen oil pan bolts and drain fluid. Remove oil pan, filter screen and "O" rings. Lift up wire loom guide and protector to disengage retaining pins from solenoid brackets.
  2. Disconnect appropriate solenoid electrical connector. Remove appropriate solenoid bracket bolts. Remove solenoid. SS1 and TCC solenoids may pop out of bore when bracket is removed. Convertor modulator valve may come out when TCC solenoid is removed.
  3. To install, reverse removal procedure. Ensure solenoid bracket engages TCC/EPC solenoid grooves and shift solenoid pockets. Clean filter screen with solvent and install filter screen and "O" rings. Using a new gasket, install gasket and oil pan. Tighten oil pan bolts to specifications. Add 3 Qts. (2.8L) of Mercon ATF and start engine. Add fluid as necessary.
scientia non olet · About LEMON Manuals