Valve Body: Reassembly

Lubricate all parts with transmission fluid. Install valves, springs, plugs, and pins. See Fig 2 . Ensure check balls are installed in proper locations. See Fig 1 . Install relief valves and springs, extension housing lube orifice, and EPC limit circuit screen. Relief valves and springs are interchangeable.
Using new gasket, apply petroleum jelly to keep gasket in place during separator plate reassembly. Install separator plate. Install solenoids and brackets. SS1, SS2, SS3, and CCS solenoids are interchangeable.

Fig 1: Location Of Check Balls & Relief Valves

Courtesy of FORD MOTOR CO.

Fig 2: Exploded View Of Valve Body Assembly

Courtesy of FORD MOTOR CO.