EEC-IV Circuit Tests: Notes
NOTE:
CIRCUIT TESTS are diagnostic formats used to test and service EEC-IV system. CIRCUIT TESTS check engine circuits, sensors and actuators. Procedures in CIRCUIT TESTS are written for the use of the following Ford Motor Co. test equipment:
- Super Star II Tester (007-0041B)
- 60-Pin Breakout Box (007-00033)
- Transmission Tester (007-0085C)
Terminal pin references are based on this equipment and appropriate overlays. All references to "test pins", "test terminals" or "jacks" refer to TEST EQUIPMENT.
When after market test equipment is used, always follow test equipment manufacturer's procedures.