EEC-IV & EEC-V Pinpoint Tests: Notes
NOTE:
PINPOINT TESTS are diagnostic formats used to test and service EEC-IV & EEC-V system. PINPOINT TESTS check transmission circuits, sensors and actuators. Procedures in PINPOINT TESTS are written for the use of the following Ford Motor Co. test equipment:
- Super Star II Tester (007-0041B) or New Generation Star (NGS) Tester (007-00500)
- 60-Pin Breakout Box (007-00033) or 104-Pin Breakout Box (014-00950)
- Transmission Tester (007-0085C or 007-0085D)
Terminal pin references are based on this equipment and appropriate overlays. All references to "test pins", "test terminals" or "jacks" refer to test equipment.
When after market test equipment is used, always follow test equipment manufacturer's procedures.