LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint System >> Removal & Installation >> Steering Wheel >> Installation

Steering Wheel: Installation

  1. Ensure front wheels are in straight-ahead position. Route clockspring (air bag sliding contact assembly) wiring harness through steering wheel opening at 3 o'clock position. Position steering wheel on steering shaft. Align marks made during removal procedure.
  2. Ensure air bag clockspring wire is not pinched when positioning steering wheel. Install new steering wheel retaining bolt and tighten to specification. See TORQUE SPECIFICATIONS  . Connect speed control wiring harness (if equipped) to steering wheel and snap connector assembly into steering wheel clip.
  3. Install air bag module. Reconnect positive and negative battery cable. Activate air bag system. Check AIR BAG warning light to ensure system functions properly. See SYSTEM OPERATION CHECK  .
scientia non olet · About LEMON Manuals