Metro & Firefly (Canadian) & Tracker
- Remove AIR BAG IGN fuse from fuse block near base of steering column. Remove steering wheel side cover. Remove Connector Position Assurance (CPA) clip and disconnect Yellow 2-pin SIR lower steering column connector.
- Remove glove box assembly. Remove Connector Position Assurance (CPA) clip and disconnect Yellow 4-pin SIR passenger inflator module connector.NOTE: When AIR BAG IGN fuse is removed and Ignition switch is ON, AIR BAG Indicator light will remain ON. This Is normal operation and does not Indicate a SIR system malfunction.
- To activate SIR system, turn ignition switch to LOCK position. Connect 4-pin connector and CPA clip behind glove box. Reinstall glove box. Connect 2-pin connector and CPA clip at base of steering column. Install AIR BAG IGN fuse into fuse block. Turn ignition switch to ON and ensure AIR BAG indicator light flashes 7 times, then turns off.