Removal & Installation

WARNING: This page is about a different variant/trim than selected.

Disconnect negative battery cable. Raise and support vehicle. Unplug Crankshaft Position (CKP) sensor wire connector from engine harness. See Fig 1 . Remove CKP sensor mounting screws. Remove CKP sensor. To install, reverse removal procedure.

Fig 1: Locating Crankshaft Position (CKP) Sensor (Typical)

Courtesy of FORD MOTOR CO.

CAUTION: When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See the COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION section before disconnecting battery.