LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls - Remove/Install/Overhaul - 4.0L) >> Fuel System >> Push-Connect Fittings >> Removal & Installation (Fuel Line Coupler)

Removal & Installation (Fuel Line Coupler)

WARNING: This page is about a different variant/trim than selected.
  1. Disengage locking tabs on connector retainer. Separate retainer halves. Disengage fitting from regulator by pushing fitting toward regulator and inserting Fuel Line Coupling Key (T90P-9550-A). See Fig 1 .
  2. To reconnect fuel line coupling, push coupler tube assembly firmly into coupler body recess until fully engaged. Pull gently on both ends of coupler to ensure engagement. See procedures under FUEL SUPPLY MANIFOLD ASSEMBLY  under FUEL SYSTEM.
Fig 1: Disconnecting Fuel Line Coupler With Key
G90B15470Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals