Ignition Coil Resistance (MX-6 & 626 2.5L M/T)

WARNING: This page is about a different car, the 1995 Mazda MX-6 and 1995 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.

Remove primary and secondary leads from ignition coil. Using ohmmeter, check the primary resistance between terminals "A" and "B" of coil. See Fig 1 . Resistance should be as specified in the IGNITION COIL RESISTANCE table. If resistance is not as specified, replace ignition coil.
Check secondary resistance between terminal "A" and coil tower. See Fig 2 . See IGNITION COIL RESISTANCE table. If resistance is not within specification, replace coil.

Fig 1: Checking Primary Coil Winding Resistance (MX-6 & 626 2.5L)

Courtesy of MAZDA MOTOR CORP.

Fig 2: Checking Secondary Coil Winding Resistance (MX-6 & 626 2.5L)

Courtesy of MAZDA MOTOR CORP.

IGNITION COIL RESISTANCE - Ohms @ 68°F (20°C)

Application

Primary

Secondary

2.5L ⁽¹⁾

.49-.73

20,000-31,000

⁽¹⁾	Remove distributor cap to measure secondary coil resistance.