Section 28 (Engine Controls - Tests W/Codes - 2.0L M/T): Introduction
WARNING: This page is about a different car, the 1995 Mazda MX-6 and 1995 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For information on MX-6 & 626 2.0L A/T models, see TESTS W/CODES - 2.0L A/T
article.
If no faults were found while performing BASIC DIAGNOSTIC PROCEDURES, proceed with self-diagnostics. If no fault codes or only pass codes are present after entering self-diagnostics, proceed to appropriate TESTS W/O CODES article for diagnosis by symptom (i.e., ROUGH IDLE, NO START, etc.).