LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 254 (Engine - 4.0L V6 - VIN [X]) >> Removal & Installation >> Water Pump >> Removal

Water Pump: Removal

WARNING: This page is about a different car, the 1997 Ford Ranger, 1997 Ford Explorer, 1996 Ford Ranger, and 1996 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Fan clutch nut has left-hand threads. Remove nut by turning it clockwise as viewed from front of engine.
  1. Remove negative battery cable. Drain cooling system. Disconnect lower radiator hose and heater return hose from water pump. Using Fan Clutch Pulley Holder (T84T-6312-C) and Fan Clutch Nut Wrench (T84T-6312-D), remove radiator fan and clutch assembly. See Figure.
  2. Remove accessory drive belt. Remove power steering pump with bracket and A/C compressor (if equipped), and position aside. Remove generator bracket with generator, and position aside. Remove accessory drive belt tensioner. Remove water pump pulley. Remove water pump retaining bolts. Remove water pump and gasket.
scientia non olet · About LEMON Manuals