LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Front Suspension (4WD)) >> Removal & Installation >> Steering Knuckle >> Removal

Steering Knuckle: Removal

WARNING: This page is about a different car, the 1997 Ford Ranger, 1996 Ford Ranger, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove spindle and shaft assembly. See SPINDLE & SHAFT ASSEMBLY . Disconnect steering linkage from steering knuckle.
    2. CAUTION: Camber adjuster must be installed in original location to maintain proper wheel alignment.
  2. Remove cotter pin and loosen ball joint nuts. Strike steering knuckle near ball joint to release ball joint. Remove ball joint nuts. Note position of camber adjuster on top of axle. See Figure. Remove camber adjuster and steering knuckle.
scientia non olet · About LEMON Manuals