LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Front Suspension (4WD)) >> Removal & Installation >> Manual Locking Hubs >> Removal & Installation (Bronco)

Removal & Installation (Bronco)

WARNING: This page is about a different car, the 1997 Ford Ranger, 1996 Ford Ranger, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove 6 bolts and remove manual locking hub cover. Remove snap ring retaining axle shaft in hub body assembly. Remove locking hub body-to-wheel hub lock ring. Install 2 bolts to remove locking hub body. See Fig 1.
  2. To install locking hub, reverse removal procedure. Tighten locking hub cover bolts to 35-53 INCH lbs. (4-6 N.m). DO NOT pack locking hub cover with grease.
Fig 1: Removing Manual Locking Hub (Bronco)
G95F27008Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals