LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Front Suspension (2WD)) >> Removal & Installation >> Axle Pivot Bracket >> Installation

Axle Pivot Bracket: Installation

WARNING: This page is about a different car, the 1997 Ford Ranger and 1996 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install axle pivot bracket on the frame. Install front and rear mounting bolts and retainers from inside of pivot bracket out through crossmember. See Figure .
    2. NOTE: Special nuts are used for this application to provide proper clearance. Use proper nuts or install a 0.20" (5.1 mm) thick hardened washer under each nut if standard nuts are used.
  2. Loosely install nuts on outside of crossmember. Tighten nuts to specification. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals