External Clutch Slave Cylinder: Installation
WARNING: This page is about a different car, the 1996 Ford Ranger, 1996 Ford Pickup, 1996 Ford F-Super Duty, 1996 Ford Explorer, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
Clean and relube clutch release shaft pivot stud, push rod pockets and fingers of clutch release lever. To complete installation, reverse removal procedure. Bleed the hydraulic system. Refer to HYDRAULIC SYSTEM BLEEDING . Depress clutch pedal 10 times to fill clutch slave cylinder and to seat components.