Removal & Installation (Pickup)
WARNING: This page is about a different car, the 1996 Ford Ranger, 1996 Ford Pickup, 1996 Ford F-Super Duty, 1996 Ford Explorer, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect clutch pedal retracting spring from clutch pedal and bracket. Remove nut holding clutch pedal to clutch and brake pedal pivot shaft. Remove clutch pedal.
- To install, reverse removal procedure. Replace pivot shaft lever. Compress retracting spring in a vise and secure with wire until it is in place. Ensure spring engages in clutch pedal and bracket slots.