Removal & Installation (Explorer & Ranger)
WARNING: This page is about a different car, the 1996 Ford Ranger, 1996 Ford Pickup, 1996 Ford F-Super Duty, 1996 Ford Explorer, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
- Pry retainer bushing and push rod off pedal pin to disconnect clutch master cylinder push rod from clutch pedal. Remove left kick panel. Remove parking brake assembly, and secure away from work area. Remove retainer ring.
- Remove clutch pedal from pedal support bracket. Inspect clutch and brake pedal bushings. Replace bushing if necessary. Refer to CLUTCH PEDAL PIVOT SHAFT LEVER . To install, reverse removal procedure. Inspect and lubricate bushings with a light film of SAE 30 engine oil.