Clutch Pedal Pivot Shaft Lever: Removal
WARNING: This page is about a different car, the 1996 Ford Ranger, 1996 Ford Pickup, 1996 Ford F-Super Duty, 1996 Ford Explorer, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect clutch master cylinder push rod from clutch and brake pedal pivot shaft lever pin. Use a small screwdriver or putty knife to wedge between lever and snap-in bushing. Remove retaining nut. Pry lever from clutch and brake pedal pivot shaft.