Clutch Pedal Pivot Shaft Lever: Installation
WARNING: This page is about a different car, the 1996 Ford Ranger, 1996 Ford Pickup, 1996 Ford F-Super Duty, 1996 Ford Explorer, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
Snap new lever to clutch master cylinder push rod bushing. Install lever onto clutch and brake pedal pivot shaft. Tighten clutch master cylinder and pedal bracket. Install retaining nut finger-tight. Ensure clutch pedal position is against up stop. Tighten retaining nut to proper specification, allowing knurled teeth on clutch and brake pedal pivot shaft to cut matching teeth in lever for correct positioning.