LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 (A/C Compressor Servicing) >> NIPPONDENSO 10P13 & 10P15F 10-Cylinder >> Shaft Seal >> Removal

Shaft Seal: Removal

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 1995 Mercury Villager, 1995 Mercury Tracer, 1995 Mercury Sable, 1995 Mercury Mystique, and 1995 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Discharge A/C system using approved refrigerant recovery/recycling equipment. Remove compressor. Drain oil from compressor, and measure drained amount.
  2. Mount compressor in vise, clamping it by mounting ears. Remove clutch plate and clutch plate shims. Remove front head from cylinder assembly.
  3. Clean compressor front hub area. Remove felt packing and dust seal retainer from inside compressor nose. See Figure . Using Shaft Key Remover (T81P-19623-NH), remove key from shaft.
  4. Remove seal seat snap ring. Clean inner bore of compressor nose. Using Shaft Seat Remover/Installer (T87P-19623-BH), remove seal seat.
  5. Using Shaft Seal Remover/Installer (T87P-19623-AH), remove seal by pushing downward on shaft seal remover/installer and rotating clockwise to engage seal tangs. Pull seal from compressor.
scientia non olet · About LEMON Manuals