LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 (A/C Compressor Servicing) >> Ford FS-10 10-Cylinder >> Shaft Seal >> Removal

Shaft Seal: Removal

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 1995 Mercury Villager, 1995 Mercury Tracer, 1995 Mercury Sable, 1995 Mercury Mystique, and 1995 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Discharge A/C system using approved refrigerant recovery/recycling equipment. Remove compressor. Using Spanner (T70P-4067-A), remove clutch plate bolt. Discard bolt. Thread an 8-mm bolt into clutch plate and remove clutch plate and shims.
  2. Remove shaft felt seal. Thoroughly clean seal area of compressor. Using Snap Ring Remover (T89P-19623-DH), rotate eye of snap ring. Pull up snap ring while holding snap ring at an angle.
  3. Position Shaft Seal Remover (T89P-19623-BH) over compressor shaft. Push shaft seal remover downward against seal. Ensure end of shaft seal remover engages inside of seal.
  4. Rotate shaft seal remover handle clockwise to expand remover tip inside seal. Pull shaft seal from compressor.
scientia non olet · About LEMON Manuals