LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 (A/C Compressor Servicing) >> Ford FS-10 10-Cylinder >> Clutch Assembly >> Removal

Clutch Assembly: Removal

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 1995 Mercury Villager, 1995 Mercury Tracer, 1995 Mercury Sable, 1995 Mercury Mystique, and 1995 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Discharge A/C system using approved refrigerant recovery/recycling equipment. Remove compressor. Using Spanner (T94P-19703-AH), remove clutch plate bolt. Discard bolt. Thread an 8-mm bolt into clutch plate, and remove clutch plate and shims.
  2. Remove snap ring. Remove pulley assembly. See Figure . Disconnect clutch coil lead. Install Shaft Protector (T89P-19623-FH) over compressor shaft.
  3. Install 2-jaw puller on compressor. Tighten puller to remove clutch coil from compressor. DO NOT use air-powered tools when removing clutch coil.
scientia non olet · About LEMON Manuals