Removal & Installation
WARNING: This page is about a different car, the 1995 Ford RV Cutaway, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
Remove third, fourth and fifth bench seats (if equipped). Drain cooling system. Disconnect heater hoses located under left side of body. Disconnect rear heater assembly harness connectors. See Fig 1 . Remove mounting bolts and lift assembly off locating dowel pin. Remove assembly while guiding heater hoses through from underbody. To install, reverse removal procedure.