Steering Wheel: Removal
WARNING: This page is about a different car, the 1996 Ford Ranger and 1996 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see SERVICE PRECAUTIONS . Disable SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Disconnect speed control wiring harness (if equipped) from steering wheel. Loosen steering wheel retaining bolt 2-3 turns. Install Differential Side Bearing Puller (T77F-4220-B1), at position marked PULL. Unseat steering wheel and remove puller.
- Remove and discard steering wheel retaining bolt. Remove steering wheel. Route clockspring wiring harness through steering wheel as wheel is lifted from steering shaft.