LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Supplemental Inflatable Restraint System - Air Bag Restraint System) >> Removal & Installation >> Steering Wheel >> Installation

Steering Wheel: Installation

WARNING: This page is about a different car, the 1996 Ford Ranger and 1996 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure front wheels are in straight-ahead position. Route clockspring wiring harness through steering wheel opening at 3 o'clock position. Position steering wheel on steering shaft and align installation marks.
  2. Ensure air bag clockspring wire is not pinched when positioning steering wheel. Install new steering wheel retaining bolt, and tighten to specification. See TORQUE SPECIFICATIONS . Connect speed control wiring harness (if equipped) to steering wheel, and snap connector assembly into steering wheel clip.
  3. Install driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE . Activate SRS. Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .
scientia non olet · About LEMON Manuals