Front Impact Sensors: Installation

WARNING: This page is about a different car, the 1996 Ford Ranger and 1996 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS . If proper torque cannot be achieved, replace stripped mounting bracket and screw with Bracket (14B191), Screw (N806327-S190), and Screw (W620397-S36). Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .

NOTE: Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with SRS is involved in a crash, and fenders or grille area have been damaged, inspect sensor mounting brackets for deformation. If damaged, system should be deactivated to ensure air bag does not deploy. See COMPLETE SYSTEM DEACTIVATION under DISABLING & ACTIVATING AIR BAG SYSTEM. Damaged sensor(s) should be replaced, whether or not air bag has been deployed. In addition, ensure body structure in area of sensor mounting is restored to its original construction.