LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (Air Bag Restraint System) >> Removal & Installation >> Steering Wheel R & I >> Installation

Steering Wheel R & I: Installation

WARNING: This page is about a different car, the 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Cab & Chassis, and 1995 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure front wheels are in straight-ahead position. Route clockspring (contact assembly) wiring harness through steering wheel opening at 3 o'clock position. Position steering wheel on steering shaft and align marks made during removal procedure.
  2. Ensure air bag clockspring wire is not pinched when positioning steering wheel. Install new steering wheel retaining bolt, and tighten to specification. See TORQUE SPECIFICATIONS  . Connect speed control wiring harness (if equipped) to steering wheel and snap connector assembly into steering wheel clip.
  3. Install air bag module. Reconnect positive, then negative battery cable. Activate air bag system. Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK  .
scientia non olet · About LEMON Manuals