LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Engine Controls - Remove/Install/Overhaul - 3.0L) >> Fuel System >> Fuel Supply Manifold Assembly >> Removal

Fuel Supply Manifold Assembly: Removal

WARNING: This page is about a different car, the 1996 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE  . Remove throttle body. See UPPER INTAKE MANIFOLD & THROTTLE BODY  . Disconnect fuel supply and return lines.
  2. Disconnect wiring harness at fuel injectors. Disconnect vacuum hose from fuel pressure regulator. Remove fuel assembly manifold bolts (2 on each side). Carefully disengage fuel supply manifold from fuel injectors by lifting and gently rocking rail.
  3. Remove injectors from fuel supply manifold, using a slight lifting/rocking motion. Place removed components in a clean container to avoid dirt or other contamination.
scientia non olet · About LEMON Manuals