LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 235 (Engine - Removal, Overhaul & Installation - 7.3L Diesel) >> Pcm Inputs >> Exhaust Back Pressure Sensor >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 1998 Ford RV Cutaway, 1998 Ford Econoline, 1998 Ford Cutaway, 1998 Ford Club Wagon, and 1997 Ford RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect Exhaust Back Pressure (EBP) sensor electrical connector. EBP sensor is located on right side of engine next to glow plug relay. Remove EBP sensor. To install, reverse removal procedure.

scientia non olet · About LEMON Manuals