LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 235 (Engine - Removal, Overhaul & Installation - 7.3L Diesel) >> Pcm Inputs >> Camshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 1998 Ford RV Cutaway, 1998 Ford Econoline, 1998 Ford Cutaway, 1998 Ford Club Wagon, and 1997 Ford RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect Camshaft Position Sensor (CMP) harness connector, located at front of engine above crankshaft pulley. Remove bolt and CMP sensor. To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals