LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 235 (Engine - Removal, Overhaul & Installation - 7.3L Diesel) >> Fuel System >> Glow Plugs >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 1998 Ford RV Cutaway, 1998 Ford Econoline, 1998 Ford Cutaway, 1998 Ford Club Wagon, and 1997 Ford RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove right or left valve cover as necessary. To remove right valve cover, remove drive belt, generator mounting bracket and generator. To remove left valve cover, remove intake ducting, crankcase breather and vacuum hose from vacuum pump.
  2. Disconnect harness connector from valve cover gasket. Remove valve cover bolts and valve cover. Disconnect wiring from fuel injectors. Remove valve cover gasket.
  3. Disconnect wiring from glow plug using a pair of pliers. Remove glow plug. If damage is evident, replace glow plug. To install, reverse removal procedure. Tighten glow plug to specification. See TORQUE SPECIFICATIONS . Ensure wiring under valve cover is routed to avoid moving parts.
scientia non olet · About LEMON Manuals