Blower Switch
WARNING: This page is about a different car, the 1996 Ford Ranger and 1996 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Remove control panel. See CONTROL PANEL ASSEMBLY under REMOVAL & INSTALLATION. With blower switch connector removed, use an ohmmeter to test switch.
- Connect one ohmmeter lead to Black wire at A/C-heater control assembly connector. Alternately connect remaining lead to each wire at blower switch connector while moving switch knob to each speed. Continuity should exist only at wires indicated. See BLOWER SWITCH CONTINUITY TEST table. If continuity exists at any other wire(s), replace switch.
BLOWER SWITCH CONTINUITY TEST
| Switch Position | Wire Color |
|---|---|
| Low | Red/Orange |
| Medium-Low | Light Green/White |
| Medium-High | Yellow/Red |
| High | Orange/Black |