LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 205 (Engine Controls - Tests W/Codes - 4.0L) >> Circuit Tests >> Circuit Test MD - Integrated Spark Output Check >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 1996 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Perform this test when instructed during QUICK TEST  or if directed by other test procedures. This test is used to diagnose the following:

  1. Step 1) DTC P1359: Check VREF Circuit Voltage At TP Sensor  Turn ignition off. Disconnect TP sensor wiring harness connector. Turn ignition on. Measure voltage between SIG RTN terminal and VREF terminal at wiring harness connector. If voltage 4-6 volts, go to next step. If voltage is not 4-6 volts, go to CIRCUIT TEST C.
  2. Step 2) Check CKP Sensor & Trigger Wheel  Turn ignition off. Check CKP sensor and trigger wheel for damage or misalignment. Repair or replace as necessary. If no faults are found, replace PCM and repeat QUICK TEST .
scientia non olet · About LEMON Manuals