Continuous Memory Self-Test (Emission Related)

WARNING: This page is about a different car, the 1996 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tester using the following steps:

Select vehicle and engine selection menu (optional). See Figure.
Select year, engine, model and any additional information requested by scan tester (optional).
Select GENERIC OBD-II OPTIONS. Press CONT button if monitors are not complete.
Select DIAGNOSTIC TROUBLE CODES.
Turn ignition on.
Follow operating instructions from scan tester menu.