KOER Switch Self-Test

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 1996 Ford RV Cutaway, 1996 Ford Pickup, 1996 Ford F-Super Duty, 1996 Ford Econoline, and 1996 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps:

Select VEHICLE & ENGINE SELECTION menu.
Select NEW VEHICLE, YEAR & MODEL.
Select DIAGNOSTIC DATA LINK.
Select PCM - POWERTRAIN CONTROL MODULE.
Select DIAGNOSTIC TEST MODE.
Select KOER SWITCH SELF-TEST.
Turn ignition on.
Follow operating instructions from scan tool menu.
After pressing TRIGGER to start test, wait 5 seconds before running through driver-operated controls. Test may also take up to 5 minutes to complete.
After test, cycle ignition off before running other tests or driving vehicle.