LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (A/C-Heater System) >> Removal & Installation >> Accumulator-Drier >> Removal & Installation (Main System)

Removal & Installation (Main System)

WARNING: This page is about a different car, the 1995 Ford RV Cutaway, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Discharge A/C system using approved refrigerant recovery/recycling equipment. Disconnect pressure switch connector. Disconnect refrigerant lines from accumulator-drier. Remove retaining screws and accumulator-drier. Cap all openings.
  2. To install, reverse removal procedure. Use new "O" rings coated with clean PAG refrigerant oil. Evacuate, recharge and leak test system.