WAIT-TO-START Indicator Does Not Turn On
WARNING: This page is about a different car, the 1995 Ford RV Cutaway, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect WAIT-TO-START indicator connector at glow plug module. See Figure . Connect a jumper wire between harness side of connector and ground. Turn ignition switch to ON position. If indicator is on, go to GLOW PLUG TESTING . If indicator is off, check light bulb and wiring. Repair as necessary.